ResinTech PPM: Waterproofing Revolutionized

This is a technical reference on ResinTech PPM (Protective Polymer Membrane) for waterproofing contractors, restoration contractors, commercial builders and project specifiers. Confirm all data against the manufacturer’s current TDS and SDS.

What is ResinTech PPM?

ResinTech PPM is a single-component, liquid-applied waterproofing membrane for commercial and industrial applications. It cures into a seamless, flexible film intended to resist water ingress, chemical exposure and UV degradation. Confirm UV/exterior and chemical suitability against the TDS.

Attributes for Contractors, Architects and Engineers (confirm against the manufacturer’s TDS)

• Seamless film: Cures into a continuous membrane without factory seams or welded joints, reducing potential leak points.

• Chemical and UV resistance: Specified for areas exposed to chemicals, salts or UV; confirm specific resistance ratings against the TDS.

• Single-component application: Ready to use; apply by roller, brush or spray with no mixing.

• Flexibility and strength: Reported 648% elongation and 2.45 MPa tensile strength per the manufacturer TDS, to accommodate movement and substrate cracking.

• Durability: Formulated for long-term integrity and wear resistance to reduce future maintenance.

Typical Applications

• Rooftop decks, terraces and balconies.

• Parkades, driveways and garages.

• Mechanical rooms, plant floors and chemical-exposure areas.

• Swimming pools, water tanks and fountains — confirm immersion and potable-water suitability against the TDS.

It is particularly applicable to mixed-material builds and designs with penetrations and transitions where flexibility and adhesion are required.

Application Advantages

• Single-component: Reduces risk of on-site mixing errors and supports faster turnaround.

• Finish compatibility: Can be specified with topcoats, tile adhesives or pedestrian coatings — confirm system compatibility against the TDS.

• Low-VOC: Formulated as low-VOC; confirm VOC values and any green-building criteria against the SDS.

Design Considerations

• Ensure proper surface preparation (clean, dry, structurally sound).

• Detail penetrations, terminations and joints per the manufacturer’s guide.

• Confirm membrane thickness and cure times against the TDS.

• Incorporate periodic inspection and maintenance into lifecycle planning.

Specifying ResinTech PPM

ResinTech PPM is supported by published performance data — tensile strength, elongation, chemical resistance and impermeability — to support specification. Substrate preparation, detailing, coverage and final performance remain the responsibility of the installer and specifier. Contact Canopus Supply for product availability and manufacturer documentation.

Technical information is provided for professional reference only. Product selection, substrate preparation, installation method, coverage, cure time, system compatibility and final performance remain the responsibility of the purchaser, installer, project specifier and/or manufacturer documentation. Always confirm suitability against the current TDS, SDS, project specification and site conditions before use.