Ardex SD-M | Designer Floor Finish Feather Finish – Gray, 10 lb

Ardex SD-M | Designer Floor Finish Feather Finish — Gray, 10 lb

One-Component Feather Finish for Skim Coating, Patching & Surface Preparation | Brand: Ardex

Ardex SD-M is a one-component feather finish for skim coating, patching, and repairing concrete, wood, and tile substrates. Low VOC, suitable for occupied environments. Gray, 10 lb bag. Confirm suitability, coverage, cure time, and application requirements against the current Ardex TDS, SDS, and project specification before use.

Key Characteristics

• One-component feather finish — mixes with water; confirm mixing ratio and procedure against the current TDS.
• Quick-setting — designed for fast return to service; confirm set and cure times against the current TDS as they vary with temperature and humidity.
• Low VOC — confirm VOC content and ventilation requirements against the SDS.
• Multi-substrate — designed for use on concrete, wood, and tile; confirm substrate preparation requirements against the current TDS before use.
• Feather-edge application — designed for thin skim coat and feather-edge patching; confirm minimum and maximum application thickness against the TDS.

Typical Applications

• Skim coating concrete, wood, and tile substrates prior to floor covering installation
• Patching and repairing surface imperfections
• Surface preparation for resin floor coatings and floor coverings

Limitations

• Confirm substrate suitability and surface preparation requirements against the current TDS before use.
• Set and cure times are temperature and humidity dependent — confirm against the current TDS.
• Not a structural repair product — confirm suitability for your specific application against the TDS.

Canopus Supply Inc. — Concrete Repair & Surface Preparation, Metro Vancouver & BC

Technical information is provided for professional reference only. Product selection, substrate preparation, installation method, coverage, cure time and final performance remain the responsibility of the purchaser, installer, project specifier and/or manufacturer documentation. Always confirm suitability against the current TDS, SDS, project specification and site conditions before use.