Mapei Mapecem Quickpatch | Fast-Setting Concrete Repair Mortar 25 lb

Mapei Mapecem Quickpatch | Fast-Setting Concrete Repair Mortar 25 lb

Fast-Setting Cementitious Concrete Patch for Interior & Exterior Repairs — 25 lb Bag | Brand: Mapei

Mapei Mapecem Quickpatch is a fast-setting concrete patch mortar for repairing interior and exterior concrete surfaces. Suited for commercial and institutional concrete floors, exterior walkways, slabs, concrete pads, and other damaged concrete areas on commercial and industrial properties. Its natural grey finish and adjustable water ratios make it a practical choice for contractors, flooring installers, and coating professionals preparing concrete surfaces for repair, coating, sealing, or resurfacing. Confirm suitability against the current TDS, SDS, and project specification before use.

Performance Highlights

Key Characteristics

• Fast-Setting: Formulated for accelerated strength gain; confirm cure times and recoat windows against the current TDS before applying coatings or sealers.
• Adjustable Water Ratio: Water ratio can be adjusted for desired consistency; confirm mixing requirements against the TDS.
• Natural Grey Finish: Blends with existing concrete; final appearance depends on substrate condition and application method.
• Interior & Exterior: Suitable for a range of repair applications; confirm exposure suitability against the TDS and project specification.
• One-Component: Add water — no liquid polymer required; confirm mixing and application requirements against the TDS.

Typical Applications

• Concrete floor repair in commercial and industrial environments
• Exterior concrete walkways, slabs, and pads on commercial and institutional properties
• Surface preparation before applying coatings, sealers, or overlays
• General concrete maintenance and repair on commercial job sites

Technical Specifications

Application Instructions

1. Surface Preparation: Remove all loose material, oil, grease, and contaminants. Mechanically prepare the repair area to sound concrete. Vacuum all dust.
2. Mixing: Add the powder to the recommended amount of clean water and mix with a low-speed drill until smooth and lump-free. Adjust water ratio for desired consistency per TDS.
3. Application: Apply by trowel to the prepared repair area. Feather edges for smooth transitions.
4. Curing: Allow to set and cure before applying coatings, sealers, or foot traffic. Refer to the current TDS for cure times and recoat windows.

Health & Safety

Read the current Safety Data Sheet (SDS) before use. Contains cement — wear dust mask, gloves, and eye protection during mixing. Wet material is alkaline and may cause skin irritation. Store in a cool, dry location protected from moisture.

Frequently Asked Questions

Can Mapecem Quickpatch be used outdoors?

Mapecem Quickpatch is formulated for both interior and exterior concrete repair applications. Confirm suitability for specific exposure conditions against the current TDS and project specification before use.

How quickly can Mapecem Quickpatch be coated or sealed after application?

Mapecem Quickpatch is fast-setting. Refer to the current Technical Data Sheet for specific cure times before applying coatings, sealers, or overlays. Cure times vary with temperature, humidity, and film thickness.

Mapei — Professional Construction Products

Technical information is provided for professional reference only. Product selection, substrate preparation, installation method, coverage, cure time, system compatibility and final performance remain the responsibility of the purchaser, installer, project specifier and/or manufacturer documentation. Always confirm suitability against the current TDS, SDS, project specification and site conditions before use.

Available at Canopus Supply — North Vancouver, BC. Authorized distributor in British Columbia.