ResinTech Protective Polymer Membrane (PPM): Advanced Waterproofing Protection

ResinTech Protective Polymer Membrane (PPM): Single-Component Waterproofing Membrane

A technical reference for waterproofing contractors, restoration contractors, concrete coating installers and commercial builders specifying ResinTech PPM. Confirm all data against the manufacturer’s current TDS and SDS.

What Is ResinTech PPM?

ResinTech PPM (Protective Polymer Membrane) is a ready-to-use, single-component liquid-applied waterproofing membrane. Once cured it forms a seamless, elastomeric film intended to resist moisture and chemical exposure. Confirm UV/exterior suitability and chemical resistance against the TDS.

Key Features (confirm against the manufacturer’s TDS)

• Single-component, ready-to-use liquid membrane.
• Seamless, elastomeric film that accommodates substrate movement.
• Formulated for resistance to water, chemicals and UV exposure; confirm ratings against the TDS.

Typical Applications

• Parkades and balconies: Protection against water intrusion and abrasion.
• Roof decks and terraces: Seamless waterproofing for commercial and institutional structures. Confirm roofing/exterior suitability against the TDS.
• Pools and water tanks: Where continuous water contact is expected; confirm immersion and potable-water suitability against the TDS.
• Concrete floors and walls: Industrial facilities, warehouses and mechanical rooms.
• Garage floors and driveways: Chemical- and oil-resistant protection.
• Metal and wood substrates: Flexible film for substrates subject to thermal movement. Confirm primer and substrate compatibility.

Application Sequence

1. Surface preparation: Ensure the substrate is clean, dry and free of contaminants.
2. Application: Apply by roller, brush or spray for even coverage. Confirm coverage rate and number of coats against the TDS.
3. Cure: Cure time is typically 8–12 hours depending on temperature and humidity; confirm against the TDS.

Technical Data (per manufacturer TDS — confirm against current documentation)

• Tensile strength: 2.45 MPa
• Elongation at break: 648%
• Tear strength: 19 N/mm
• Solid content: 88.5%
• Drying time: ~9 hours
• Water impermeability: 100%
• Heat and chemical resistance: confirm specific ratings against the TDS

Packaging

10-litre pail, ready for direct application on site.

For technical data sheets, bulk orders and volume pricing, contact Canopus Supply.

Technical information is provided for professional reference only. Product selection, substrate preparation, installation method, coverage, cure time, system compatibility and final performance remain the responsibility of the purchaser, installer, project specifier and/or manufacturer documentation. Always confirm suitability against the current TDS, SDS, project specification and site conditions before use.